- The process of mixing the metal material we determine the easiest, we use 925 silver. With so in reference to the provisions of the easterling family then the ratio becomes 92.5% pure silver and 6.5% is copper. Actually for a nice silver alloy can also with some other metal even not infrequently I can memamurkan silver five metals at once. In this case the fox is composition 6.5% while the 92.5% as a fixed variable But I am not currently wanting to highlight the mixing of metals and what are the advantages (then the impact), now I am more to the technique of making simple, with the simplest tool.
If it is contained in the composition of silver 92.5% and 6.5% of copper materal is melted into one in the koy that has been stirred with pijer and belching, then spilled into the singen (iron mold).
Dip into the water to make it cold, pantek (wrought) above the paron (wrought iron), do this repeatedly so that the shape of the box, solid and proportional.
The purpose of why should be burned first, so that the metal softer when forged, in addition to minimize the risk of crack. Forging alone means that the metal is solid, not hollow, as well as elasticity test, if the mixture of silver is bad will tend to break.
After the milled heat box to form on the box grinder, (if I have a box mill, rattan slope grinder and flattened mill)
Heat, water-dipped, wrought, flattened rollers.
At the time of grinding gepeng, the most important so the attention is, adjust the thickness of the gemstones are planned in pairs with metal thickness.
In each end cut to square, measured the length of the ring to be adjusted with the circumference of our fingers. If the thickness, length and width are less suitable the metal in the heat again to then enter the pile milled flattened.
After the rollers are measured again, length and width. In terms of thickness, it is important to be in the know suitability thick gemstone with a metal thickness, if the metal is too thin to worry about the end of the stone can be transparent and finger prick (for rock sharp edges), and it was less comfortable when in use, jka too thick, wasteful Raw materials and means increased costs.If so, wrap it so that the tip ends meet each other in a circle ring, proceed with connecting to the way in solder (in the las ...., Stained in another term often called connect permanently to the manner in heat), because silver, a mixture comprising patrinya from 1 mixture of metal with a ratio of 1: 2 (often called the stained one-two, 1 gram of pure silver compared with 200 mg of brass. If the gold composition of the solder is formed in accordance with the levels of gold jewelery) boiled with alum, so kotroan oil (for machinery mill ) And the pijer is really clean. Stingy until it all looks flat (especially on the connection),
Put into the sunglon (iron ring without the size of the number, if the size of the bracelet in my name satong) afterwards in the fine sandpaper wrapped in the stick and in the clasp pake hanging drill
Adjust the distance between the gems (if the permeate is more than one), the size of the boran with the diameter of the stone (if I use the run), if it starts in drill to make a hole (where the rock), from the first translucent drill, heart drill, , Drill drag or drill plate. If you live pasng gemstone claws.
To the inside difficult to reach Polish with hanging borane (picture missing although this includes a pretty important part as well) by wrapping cotton on a broom that has been given medication polish chocolate (remember "mirif" chocolate is not chocolate actually or shape Others that resemble shrimp paste, or similar red ground overgrown with rambutan trees),
**Thanks for read my post, follow me, resteem. **