
Hello to all the Hive community!
I hope you are doing well. To continue with the Bob Builder style improvements, I bring you the chapter of:
Changing the look of my closet doors. Again I had a conflict with the color they had, BROWN! And as you know, it's not my favorite, I like them lighter and combine them with some dark but to apply them in details.
Hola a toda la comunidad de Hive!
Espero se encuentren muy bien. Para continuar con la onda de las mejoras al estilo Bob Constructor, les traigo el capítulo de:
Cambiando el aspecto a mis puertas de closet. Nuevamente tenía un conflicto con el color que tenían, MARRÓN! Y como ya saben, no es mi favorito, me gustan más claros y combinarlos con alguno oscuro pero para aplicarlos en detalles.

I already had the light gray paint I had used on the bed This is how I renovated my bed - ENG/ESP and for the romanilla I wanted another color, so I went to the hardware store and started looking for a combination. In conclusion, after looking around for a while I decided on a dark gray. I had the paint made and with that, I was ready to start my project.
Ya tenía la pintura gris claro que había usado en la cama This is how I renovated my bed - ENG/ESP y para la romanilla quería otro color, así que me fui a la ferretería y empecé a buscar una combinación. En conclusión, después de ver un rato decidí por un gris oscuro. Mandé a hacer la pintura y ya con eso, estaba lista para iniciar mi proyecto.
I had everything ready, the brush, the two paints, tape to cover the edges and avoid staining, plastic bags for the floor and the roller.
In order to fix the doors of my closet, I had to work a little harder, first I had to remove the hinges, so I looked for a screwdriver; I have several at home because I'm always inventing something, then I started to remove one by one until I could remove the 3 doors.
Tenía todo preparado, la brocha, las dos pinturas, cinta para tapar los bordes y evitar manchar, bolsas plásticas para el piso y el rodillo.
Para poder arreglar las puertas de mi closet, debía esmerarme un poco más, primero había que quitarle las bisagras, así que busqué un destornillador; tengo varios en casa porque siempre ando inventando algo, luego empecé a sacar una a una hasta que pude retirar las 3 puertas.


Then I had to remove the mirror that had one of the doors but it was stuck with tape on both sides and it took me a lot to do it, in the end I managed to do it but I broke the glass. I had to remove it because I was going to change the wooden handles and replace them with stainless steel ones.
Luego tocaba quitarle el espejo que tenía una de las puertas pero estaba pegada con cinta pegante por ambos lados y me costó muchísimo hacerlo, al final lo logré pero partí el vidrio. Tuve que quitarlo porque iba a cambiar los tiradores que eran de madera y los sustituiría por unos de acero inoxidable.

When I finished fighting with the mirror I could start sanding the doors like crazy, we must remove the varnish layer, it is very important for the paint not to peel off if we are going to use water based paint. If it is oil based, it wouldn't matter much.
Al terminar de pelearme con el espejo pude empezar a lijar como loca las puertas, debemos quitarle la capa de barniz, es muy importante para que la pintura no se despegue si vamos a usar pintura con base en agua. Si es en base en aceite, no importaría mucho.
When I finished sanding, sanding and sanding I proceeded to paint with the light gray all the doors, except the romanilla. To these I put tape so they would not stain with the other gray. Then with a small brush I applied the other gray to the romanillas and to match, I painted the frames with the same dark gray.
Al finalizar de lijar, lijar y lijar procedí a pintar con el gris claro todas las puertas, menos la romanilla. A estas les puse cinta para que no se mancharan con el otro gris. Luego con una brocha pequeña apliqué la otra gris a la romanillas y para que hiciera juego, pinté los marcos con ese mismo gris oscuro.



When they were ready and dry, I proceeded to place the steel handles and then I mounted each one in its place with the same hinges that I had removed and I had a renovated closet with little money.
I hope you liked my post...
Greetings!!!
Cuando ya estaban listas y secas, procedí a colocar las manillas de acero y luego las monté cada una en su lugar con las mismas bisagras que había quitado y ya tenía un closet renovado y con poco dinero.
Espero les haya gustado mi post...
Saludos!!
