A friend of mine 
If your new to aquaponics you may not think much about the pump you buy to run the system BUT sometimes all is not as straight forward as you would expect.
When you buy a pump be mindful of the head lift (height in feet the pump can raise the water), gallons per hour (gph), and pipe size.
This particular pump says 19 ft head lift and 2500 gph.
However this will NOT pump 2500 gallons of water per hour at 19 ft of lift.
What is not so obvious is that the rating on the box of 2500 gph is with a 2 inch pipe with zero head lift. For every foot the pump has to lift the water, the gph rating drops.
Look closely at the box it says, 2500gph at 0ft, and 0 flow at 19ft.
These pumps do not produce a lot of water pressure either, so reducing the pipe size will ALSO REDUCE the gph. Conventional wisdom is that reduction of pipe size increases pressure but the overall volume of water is close to the same. THIS IS NOT TRUE WITH THESE PUMPS.
My system has a 5 ft head lift with a 3/4" pipe.. I get approximately 380gph of water flow from this pump. With the same pump and 1-1/4" pipe I can get 600+ gph with a 5 ft head lift, and with a 2" pipe it may increase to 800 gph.
The thing to remember with these pumps is that the gph is rated with zero lift at the pipe size specified. Since no system is going to have zero head lift, you can safely assume that the gph rating will not apply AS STATED ON THE BOX.
Furthermore, the gph rate is not linear with the head lift. In other words you cant simply divide the gph by the head lift and get a flow rate for a specific rise. The gph decreases exponentially with increase in lift until you reach the maximum lift and flow drops to zero.
If your using a typical IBC tote for a fish tank then you will likely wind up having to have, what would at first glance appear to be, an over sized pump.
So how much water should you exchange?
For the hobby, or beginner level aquaponics it is fairly safe to say that you have to exchange the entire water volume of the fish tank at least once per hour.
If you go out and get a typical 600gph pump with a head lift of 10ft and your using a 1/2" return line, chances are your getting about 1/10th of the rated amount. So in a typical 330 gallon tote you would be exchanging the water roughly every 5-1/4 hours, instead of every hour.
This situation will leave your entire system lacking in the necessary water flow to be effective.
With this kind of exchange rate, depending on your fish density, you will likely wind up with low oxygen, and high ammonia. This is not an effective flow rate to remove the solids from the fish tank either.
Also when you install your pump, make sure to use a union near the pump so the pump can be removed for cleaning without cutting the pipe.
Also you will want to install a ball valve on the return pipe somewhere close to the fish tank so you can control the amount of water coming into the fish tank.
You can always reduce the flow of the water by using a combination of reduced pipe size and a ball valve. But you CAN NOT INCREASE THE WATER FLOW with an under sized pump.