Hello Steemians friends, today you can make a nice tendril if you follow the steps that I will tell you next, in a few minutes you can use it.
The materials to use:
- Tip flat, round, other silicone and cutting
- Wire No. 20 and
- Round stones or crystals
Step 1. The wire should be inserted through the hole in the ball, as you will see in the photograph.
Step 2. With the flat clamp you take the tip and bend the wire so that the stone does not come out.
Step 3. Once you finish working on that tip, you go to the other end with the round tip clamp, turn the wire and pass it under the tip of the clamp.
Step 4. Then you give it three turns on its own axis, as you will see below.
Step 5. At the end of giving the turns you want, you cut and make a loop with the point left over it will remain as an ornament.
Step 6. For the hook it is necessary to cut two wires of 5 cm.
Step 7. Take the two wires and place it on a pencil or pen and fold it almost in half.
Step 8. Then take the two ends with the round clamp and bend slightly backwards.
Step 9. Then you take the other two points and make a small circle where you will set the stone.
Step 10. At the end you will have a beautiful tendril like the one you will see in the next photograph.
If you have any doubt you can ask me with pleasure I will answer you.
Step by step guide developed by
