As many of you know I have been doing a lot of 3d printing and designing lately. Recently it was my good buddy Hive account@deadspace birthday, and in celebration. I created him his own monster! I know many of you have monsters created by me but this one is a bit different.

As you can see, it is a 3d model rather than my typical 2-D monster, drawn on paper or my tablet. Even during my times of silence on steemit, Hive account@deadspace and I have been in fairly constant communication. Since I have taught myself new skills, I thought it would be a perfect time to try something new for him.

After designing the model, I then printed it on my 3d printer. It turned out really good! Like any print, I had to clean of the supports, and sand it a bit. After the prep work, I drilled a few holes and added thermostat wire for arms and legs. To make the hands and feet, I used hot glue. I also added hair, eyebrows and NIPPLES using hot glue. The nipples were a special treat just for Hive account@deadspace and his monster is the only one whos nipples you can actually see (considering the monster shaves his whole body on a daily basis). This helps his nips be free from all that pesky fur, and can be out in the open, ripe for twisting.

After getting him all assembled, I primed him grey and cleaned it up a bit more.

This is part way through the painting process. I painted him green and black because Hive account@deadspace is a wannabe amyboi. He loves guns and knifes and stuff.... So in addition to the nipples. I gave his monster a grenade launcher and some ammo cans. So not only is the monster IN heat, but he is packing heat too!

Oh you wanna see the finished product???

TO BE CONTINUED ON @DEADSPACE page

will add link when his lazy ass posts it