First of all, the fact that the plant does not block the light, it can be easily transported to the place by car. set on its own and it will be longer.
every fence begins with the pillars. For mesh fence may be any steel or asbestos cement, concrete, wood. When installing the poles do not have to be cemented. Pouring cement base increases the complexity of the work and at the same time does not guarantee that the poles are not rickety and will not be pushed out the frozen ground.
is sufficiently durable strengthening of the four pillars of bricks, zaglublёnnymi flush with the ground. In this way, uneven thawing and freezing of the soil is practically no effect on the stability of the pillars. In an extreme case, the misalignment are easy to correct.
The easiest way to install steel pipes: they are slaughtered with a sledgehammer - it can be done alone, or "woman", while working together. Under columns of other types of digging pits, wells are drilled. If your site has running water or in the grower has a water pump, the drilling can be carried out hydraulically.
Net often marketed by 10-20m rolls, width 1.5 m. These dimensions are optimal. When mounted on poles grid is raised to 15-25 cm above the ground in order. to be able to legkoo swath of grass under the fence and to the bottom of it less rust. From the neighbor's chickens is easy to protect segments of the boards or strips of slate, posed on the edge. The total height of the fence will quite sufficient - to 175 cm
with spans between the pillars of 2-3 meters are fixed to the grid does not bend or sag, even without a garter to the stretched wire or wooden prozhiliny. However, such a fence does not look very nice, besides easily crawl under it, we need only lift the bottom edge. Several looks better mesh, fixed to the wire (diameter 5-6mm), stretched between the pillars. It looks good hedge, which at the top and bottom poles are wooden prozhiliny, to which is attached a grid. Prozhiliny boards made of 30-40 mm and a thickness of about 100 mm. To the post of screw bolts. A combination of clear and upper and lower bounds with fishnet mesh fence gives elegant look.
Most good-quality and beautiful turns fence of metal sections in the form of frames, to which the welded mesh. Suffice 1.5h2.5m section of the metal angle.
When you install the most trouble delivering corner posts. They are loaded with forces acting at an angle of 90 degrees. In moist soil columns bend inward area, mesh them slack. Strengthen them in several ways. If you have plenty of long pipes, their mounted vraspor between the top of corner post and a base adjacent to it hardness obtained excellent design.
When available, there are only short pieces of pipe, they, too, can take advantage of: one end of them rests on the middle of the corner post, and the other buried in the ground, placing it on a flat stone or plate. These struts will bear the burden and will not let crooked poles.
In the case of devices fence with wooden or metal frames prozhiliny specially strengthened corners is required.
Before pulling the grid need to dock the individual pieces together. The easiest way to do this one of two ways.
First - separate (unscrew) the extreme wire to attach to each other the ends of two pieces, and then connect them by screwing the wire back. No connection should be not much will.
The second way: the ends of the pieces are connected by a line segment of wire, threading their cells, like spokes.
In either method, the wire is better divided into two parts in order to connect the counter pieces on both sides. Push the wire by half the width of the grid is much easier.
Once connected to the grid, it can be hung from the pillars. If they are mounted wooden prozhiliny, this operation is not difficult: the net is slightly tensioned and nailed. If it is necessary to hang onto the wire or only the pillars in this case require a sufficiently strong tension. There are many ways to pull the net. But above all it is necessary to pass through extreme cell steel rod or reel him of the net, securing it with wire. By this tie rod wire, through which the tension. Several devices shown in the figures. The easiest way to use the lever - long a strong pole, one end of which is lowered into a hole (not sliding), for the other pulling ropes and attached to the middle of the grid.
Other take-up is based on the principle of onion: strong double twist rope or cable. You can apply a threaded compression sleeve. In both cases it is necessary to have, for that catch or clutch onion: wood. pillar structure, or dug into the ground beam. Sometimes the tension using the machine.
To secure the net poles in the simplest case, a wire (preferably stainless) or bolts with large diameter washer - it is reliable and accurate.
The final and most important operation - coloring. Mesh Coating - work is extremely time consuming, with menbshe than the cell, the more difficult to paint over them. So try to buy a grid with large cells (30-50mm). She looks beautiful and painted quickly.
Work comfortably together, standing on both sides of the fence against each other. Each color to his side, helping to paint a different weave - the most remote places. We must act with a brush, paint roller does not weave paints over.
Melkoyachistuyu grid advisable to paint directly on a roll, dipping method. This method is ten times faster operation, gives 100% staining, but it requires several high paint consumption. The paint is poured into a bath of suitable size to a level of poovinu roll diameter. The mesh is placed in the bath and rotated until it is completely paint over. excess paint is allowed to drain into which a container. This paint is returned to the bath.
Rolls of dried and carefully roll, taking care not to contaminate. After the sample grid damaged places reformats. Fair work pays off with a vengeance: grid downtime, without requiring