how are you friends, I want to share today's experience, this is my first post here, hopefully it can be useful for all my friends. And sorry if there are many mistakes and if you like my post, please leave your comments below.
I want to share my story this afternoon with my best friend, went to a welder, wanted to make a pedicab, because I was in my hometown, I was making a small business, namely making cooking water and I was selling village rivets, so I needed a pedicab to deliver water to buyers, because if I take it by car, it's a bit cumbersome, after all, the load is also small, but if I use a trishaw, the load is also quite large.
This is the initial stage of the pedicab making process, namely by using a long iron, then the iron is cut into smaller pieces like the picture above, to make the installation process easy. This work is indeed very easy at first glance, but if this is done by people who are not experts, the results are very unsatisfactory.
this is the initial stage, after installing all the iron in the weld, then the embrace is already in the form of a rickshaw, the next step is to put tires on the rickshaw, after installing all the new rickshaws can run and this is a picture of the rickshaw that has been installed with tires
tahab which is almost complete, after the installation of a frame like this, then just wait on the board, so that this rickshaw can accommodate all the goods, then I will show the picture below as a picture of a handyman making a rickshaw
It's not all finished yet, so from this, it still has to be done in a few more days, because the process of installing the boards is a bit complicated, so it takes a bit longer.
So for now this is all I can show, thank you for visiting my post