Spa Cleaning, Harvest, Glass Studio Construction, Trailer

It was time yesterday morning. We had put off draining the spa for too long and the water was in dire need of a refill.

Once out I dropped some of the cleaner into the water and let the jets roll for half an hour and scooped foam out onto the ground. The cleaner helps to scour the lines and the tub to get bio-film and whatever else get stuck to the lines.

Then the pump went in and I drained all the water out.

While it was draining I went and got the squash piked in the garden. They gave me over 20 pounds again after the slight lull.

The spa drained I put the hose in and got it filling for another foaming scrub. While it filled I got the fans installed in the studio. I had to put the fans in the board and attach them before I could lift them into place.

Our friends showed up for the afternoon and shortly after the arrived I got the second foaming rolling which Hive account@stryeyz and Nancy scooped the foam.

While they scooped I wired in the first fan. I have the fan run to the light switch above the outlets and it works wonderfully. The fans only use 1.4 amps so I don't need crazy wire, the stranded works great.

I wired in a plug to the outlet and then plugged it into an extension cord which allowed me to run the fan. It gets damned hot in the studio without the fans running right now.

The second foaming finished I got the pump in and drained out the water. Once the water was out I pulled all the jets out and they went in the house to get cleaned.

We got the last bits of debris removed once all the water was out and cleaned everything before getting the hose in and filling the spa. It was at mid 50s F so was not warm enough for us to use in the evening, it is ready this morning though.

The butterflies are really enjoying the marigolds. Their long proboscis probing at the flowers as they roam around the petals.

The table saw got drug over to the tool shed and I ripped a length of board in half to use as my ceiling supports. The table saw now FINALLY is in the tool shed where it belongs and not under the carport.

The insulation is all up on the main back wall around the fans. The board is in overhead and I have a temp light installed.

The sheets of aluminum that came off the roof of the studio were rather rumpled and I needed to get them flattened out. To do it I dropped them onto the concrete patio and using the piece of wood I would slide the wood a bit then jump on top of it. This worked rather well at smoothing out the metal. I ten measured 19 inches from wither end and bent the metal in a 90.

The metal is the back wall that the torches will be firing at.

On my exhaust fans I stapled some screen over the outside to keep bugs from easily getting in when the fans are not running. I have no roof on it yet but this is so I don't forget to do it later.

Our friends headed out to go pickup their Azure order which Hive account@stryeyz went to take care of. I had to get the trailer hooked up for my grain run that I have already done this morning.

I got the 3rd piece of metal bent and set in the studio and today I will get them installed. My goal is to be blowing glass today.

Chances of storms today so I have to make sure things are covered around the farm, have harvests to get to, empty the barrels of grain, get my studio going enough to get my torch setup and working, and keep at the cleaning and organizing.