Hello Everyone,
This morning I 3D printed a guitar capo, and not only did it print beautifully, it also works perfectly on my Jasmine guitar as well!
I found this design on Thingiverse, as a second attempt at printing a guitar capo. The previous capo snapped as soon as I tried fitting it on my guitar. This one is a little bigger and seemingly much better designed. I watched as it printed and could see special care was taken in the design work to ensure it would react correctly to spring pressure. LoboCNC did a really good job with this.
It only took two hours on my slow but steady printing Ender 3 V2, @ 0.28 mm layer height, printed in black TECBEARS PLA.
Perhaps we will see more of this capo in use over on the 
That will do it for this post.
Your time is a valuable commodity and I always keep this in mind and do my best to respond to everyone. I appreciate all of the amazing engagement and support!
Thanks for stopping by, have a great day! ~~
▶️ 3Speak