Hello, today I bring you the mold of a wide pants, the sizes go two by two, so they start at 36-38 and end at 54-56, with the colors that represent them.
In the case of the front mold, the pocket is optional, I did not make it.
Rear mold.
Both in the waistband, as in the front and rear mold, all the measurements in the pen are not modified according to the size, but are always the same.
This is how the cut mold would look, I made size 36-38, remember to leave 1.0 cm for the seam allowance.
Well, the first thing we are going to do is sew the shots, joining the two front and the two rear ones. The image corresponds to the front shot.
When we already sew the shots, what we will do is sew the sides, external and internal of each side. Remember that I did not make the pockets.
For the waistband, being in this case an elastic fabric, what I did was reduce the total length and cut it about 5.0 cm less. If you want, you can cut it a little more or a little less, that depends on each taste. The positioning of the waistband should be done as follows: the four points of the pants (the four seams) are marked on the waistband, then the same is secured on the pants with each mark in each seam. At the time of sewing, they step on the foot of the machine and lower the needle, then they stretch the waistband next to the pants, making the seams coincide with the marks and sewing.
They can also pass an elastic, for that they must cut the waistband, without reducing it, while reducing the elastic.
Finally, they make the hem of each leg, sew and voila, they have finished a wide pants.
This is what the pants would look like once finished.