UN BOLSO PARA HERRAMIENTAS.
A BAG FOR TOOLS
Hola a todos en la comunidad de Hive Diy, un abrazo para todos.
Hoy les traigo un bolso para herramientas de material reciclado que voy a hacer para un amigo, como pago de una deuda de una torta de cumpleaños, que él me hizo hace tiempo y que en ese momento acordamos que le haría un bolso que el necesitaba para cargar herramientas ya que también él es mecánico.
Hello everyone in the Hive Diy community, a hug to all.
Today I bring you a bag for tools made of recycled material that I am going to make for a friend, as payment of a debt for a birthday cake, that he made me a long time ago and that at that moment we agreed that I would make him a bag that he needed for load tools since he is also a mechanic.
Así que en estos días se consiguieron los materiales y por fin voy a salir de esta deuda, con la confección de este bolso para herramientas, que les mostraré a continuación
So these days the materials were obtained and I am finally going to get out of this debt, with the making of this bag for tools, which I will show you next.
Materiales:
Un retazo de semicuero
Un cierre
Aguja
Hilo
Tijera
Materials:
A piece of semi-leather
A closure
Needle
Thread
Scissors
Primer paso
Cortar las piezas, esto se me dificultó un poco porque tenía que cuadrar de manera exacta para que salieran todas las piezas del retazo de semicuero, me tomo unas horas cuadrarlo, pero lo logré.
Todas las piezas
2 piezas de 36.5 cm x 28 .5 (que son los laterales)
1 pieza de 36.5cm x 36cm (la parte de abajo)
2 piezas de 70 cm x 18 cm (estas son donde va el cierre o la parte de arriba)
2 piezas de 28 cm x 11.7 cm (las pestañas que van a los lados del cierre)
First step
Cutting the pieces, this was a bit difficult for me because I had to square it exactly so that all the pieces of the semi-leather piece would come out, it took me a few hours to square it, but I did it.
All the pieces
2 pieces of 36.5 cm x 28 .5 (which are the sides)
1 piece of 36.5cm x 36cm (the bottom part)
2 pieces of 70 cm x 18 cm (these are where the closure or the top part goes)
2 pieces of 28 cm x 11.7 cm (the tabs that go to the sides of the closure)
Lo último que me faltaba era cortar las asas y también las saque, aunque hubo que hacerle un empate.
4 piezas de 18 cm cada una para unirlas de dos en dos y formar la aza de 36 cm.
The last thing I needed was to cut the handles and I also took them out, although it had to be tied.
4 pieces of 18 cm each to join them two by two and form the 36 cm aza
Second step
After cutting all the pieces I proceeded to glue the closure and then the tabs on both sides to complete the length of the piece and finally the azas
Then, on the other hand, assemble the lower cover with the sides, in order to glue it and finish it off, after that, join it with the previously finished upper cover.
Finally, assemble the two previously assembled covers, each one separately
And after assembling each of the pieces separately: first the handles, then the top cover and finally the bottom cover, I proceeded to glue it.
Así quedo el producto terminado
This is how the finished product turned out
