When we are trying to photograph models like you are, everything turns into laughter, the wind is wonderful playing at not having the leaves and flowers static. Needing several takes to get what we want.

When I finally decided to use this photograph to show it, well give the potential it had and I took part of it to work on it. This is the unchanged photo:

As I mentioned before, I had to use only part of the photo and this is what I got:

Now is ready for adding details of edition:

To carry out this edition I started by eliminating some spots that the leaves had and that I didn't like because they distracted the attention from the focal point... The flowers. Then I removed the shine a little with a dark green in a translucent layer, select the flowers with the magic wand of the ibispaint program, this to be able to erase the translucent layer on the flowers and apply it as more color so that it will stand out a little. Inverting the selection, I decided to put a bit of blooming green in the upper right and a bit of black in the lower left, thus unifying the light in the image. We now proceed to take a duplicate of the original image and place them on all the other layers, applying the transparency of the layer to 30%, to restore the brightness to certain sheets. Finally, I applied the signature by a thick dark green border and the filling in white so that when I put transparency the design that is below would be seen.

Here is the definitive Photo so you can better appreciate it with details:

These were other photos I took with these fussy models, but I did not like the sharpness of the flower border: