
Evangeline tendrils
Hello! Today I'm going to show you how I made this pair of earrings, which I called Evangeline, they are very easy to make and very few materials are needed, let's start with the tutorial.
Materials:
- Number 10 and number 12 copper wire.
- Jewelry pliers.
- Metal file.
- Pencil.
- 2 Czech crystals.

We will cut 2 pieces of 7 cm from the number 10 wire and pass the ends through the file so that they do not hurt.


<div class=text-justi
Then we shape it with the clamp, we make the two rings, upper and lower of our piece.


With the help of the same clamp we make the necessary curves to give the characteristic shape of the tendril.


Then we make a small setting in each Czech crystal, with two pieces of 4 cm thread of the number 10, we make a ring and a termination so that the crystal does not come off.

Finally we make the hook that goes inside the ear, with two pieces of wire of 7 cm each, we help ourselves with the pliers to make the lower ring and with a pencil to make the curved shape.

The last step is to put all the pieces together and send them to the electrolytic bath and this is the result!



Zarcillos de Evangeline
¡Hola! Hoy les voy a mostrar como hice este par de aretes, que llamé Evangeline, son muy fáciles de hacer y se necesitan muy pocos materiales, comencemos con el tutorial.
Materiales:
- Alambre de cobre número 10 y número 12.
- Alicates de joyería.
- Lima metálica.
- Lápiz.
- 2 cristales checos.

Cortaremos 2 piezas de 7 cm del alambre del número 10 y pasamos las puntas por la lima para que no lastimen.


luego le damos forma con la pinza, hacemos los dos anillos, superior e inferior de nuestra pieza.


Con ayuda de la misma pinza hacemos las curvas necesarias para dar la forma característica del zarcillo.

Luego hacemos un pequeño engarce en cada cristal checo, con dos trozos de hilo de 4 cm del número 10, hacemos un anillo y una terminación para que el cristal no se desprenda.

Finalmente hacemos el anzuelo que va en la oreja, con dos trozos de alambre de 7 cm cada uno, nos ayudamos con la pinza para hacer el anillo inferior y con un lápiz para hacer la forma curva.

El último paso es unir todas las piezas y enviarlas al baño electrolítico y ¡este es el resultado!

.
