F1 Racing Car
Hello my dear friends, days without doing anything about Wire Art. But I had run out of the most Essential material: Copper Cables and Wire. So I set out to get in materials that were going to be thrown away and got some good pieces of Cable that would become future creations.
This time I wanted to make an F1 Racing car model. Try to make it as close as possible to reality, I hope you like it. I always start from the base of copper wire with its respective tin solder.
Materials
COPPER WIRE.
Tin and soldering iron.
Pliers and tweezers.
For the ornament:
Colored glossy paper black and blue.
Glue and scissors
The first thing was to cut four copper strips of 25cm each in order to remove the main part of the car's chassis, forming its particular Diamond shape.
After forming the main structure, it is necessary to reinforce with cross welds in the shape of an X, just like the real F1 cars.
Then design the system where the wheels will go: wind a wire and the axles of the wheels will pass through there, which will be two metal rods that rotate smoothly on their axis. (the rubbers will be almost at the end). The structure will also continue to be reinforced.
Reinforced the structure, you have to make the front wing, and this was with three 8cm lines, which were glued to the front of the chassis. Also in the same way will be done with the rear wing. (Previously in the formation of the Chassis, he had left a foundation to stick the rear wing there).
Formed the ailerons, I put an oval in the upper part that will be the entrance to the car.
Now with the help of my Dremmer and some 1-inch pvc pipes I cut the 4 car tires (the back ones are wider than the front ones).
With the rubbers already cut and some rubber rubber, I proceed to line the wheels and mount them to the car. Leaving everything almost ready.
Now the only thing missing is a decoration with colored paper (I used blue and black)
The Formula 1 style racing car is ready. I hope you like it and if you have any questions, write to me and I will gladly answer you ... Thank you for all the good comments and for the support received ...
All photos are my property, taken with my Samsung GT-I9063T phone.