Виявляється, що навіть коли все розрахував, передивився безліч відео, як інші роблять подібні речі, на практиці не все так просто складається. Робота робилась дуже повільно, бо постійно доводилось по декілька разів виміряти,багато різати, а саме складне- прирізка дерев’яних брусків під кутом, бо довелось робити це ручною пилкою і різати майже повздовж волокна. А ще майже перед закінченням монтажу каркасу теплиці вийшла з ладу біта, і виявилось, що вона в мене була єдина. А вже після того, як я змонтував каркас, то побачив масу недоліків в проекті, які тепер буду усувати на місці. Це стосується і системи кріплення плівки і жорсткості самого каркаса. На виготовлення цього каркасу я витратив два дні,але я задоволений, що процес пішов і є певний проміжний результат. Мене сьогодні не зупинив ні ранковий сніг, ні повітряна тривога, що лунала три рази на протязі дня.
It turns out that even when I calculated everything, watched a lot of videos of how others do similar things, in practice, not everything is so simple. The work was done very slowly, because it was constantly necessary to measure several times, to cut a lot, and the most difficult part was to cut wooden bars at an angle, because it had to be done with a hand saw and cut almost along the grain. And almost before finishing the installation of the frame of the greenhouse, the bit failed, and it turned out that it was the only one I had. And after I mounted the frame, I saw a lot of flaws in the project, which I will now eliminate on the spot. This also applies to the film attachment system and the rigidity of the frame itself. I spent two days making this frame, but I am satisfied that the process has gone and there is a certain intermediate result. Today, neither the morning snow nor the air alarm that sounded three times during the day stopped me.