Drawing of building with Autodesk sketchbook

Hii Guys
Today i created a building with Autodesk sketchbook.
Firstly, I used the perspective. I started by choosing the two point modes. Then i switched to the constrained grid and pulling on the green dot to adjust the upper and lower point. Then customizing the grid by increasing and decreasing of the density and opacity. I tried to make sure that the lines meet that exert points. For the drawing, i made use of the Technical Pen. I defined the proportion of the building and the ground floor and i started to draw. Then fill in with colours. It took me 5hours to derive the building.
The lines were not really straight because this is my first drawing this. With time i will get used to it.
Process

TOOLS
AUTODESK
TATTOO INKER -TO MAKE THE MIRROR EFFECT
SMUDGE WEB BRUSH
INKING PEN
CHALK PASTEL -FOR BRICKING EFFECT

THANKS FOR VIEWING MY BLOG