Alright, finally part 4 into this series!
Last time we ended with all of the model halves glued together. This time, we get to deal with one of the byproducts of that: the model gap.
[picture of model gap]
A model gap is pretty much exactly as it sounds - an air gap between parts of the model. In my case this gap was the area between the halves that I glued together.
Now, leaving the gap in would've been fine since sometimes it doesn't usually hurt the model aesthetically, but I wanted to see if I could do something about it.
And lucky for me, there is a way to deal with these gaps! Turns out there's this stuff called modeling putty that's made exactly for this reason - you fill in the gaps, let it dry, sand off any remainder and away you go.
And here it is initially applied to each piece:
And after that was sanded down a bit:
The only issue I ran into was that some of the putty didn't fill in correctly and actually fell out of the gaps when I trimmed/sanded the putty down:
So I had to fill those gaps in again and re-sand. Not that difficult to do, but still something to watch out for.
So far I'm liking how this model is turning out! Next up will be the start of priming/painting, so look forward to that!
Previous Parts:
Part 3: Gluing the halves together
Part 2: Trimming and De-warping
Part 1: The print