Here's my entry to a fun little design challenge hosted by
.
NINTH WEEK'S AVAILABLE RAGTAG RESOURCES
Pick Three
Four 2x6 Boards, 10' Long
Three 5' x 16' Cattle Panels
Twelve 12" x 12" x 2" Concrete Pavers
Four 5 Gal Plastic Buckets
TOOLS
Pick Three
Hammer ~ Saw ~ Drill ~ Shovel ~ Cart ~ Tin Snips ~ Wedge
Trowel ~ Rake ~ Post Hole Digger - T-Post Driver
Your choice on power or hand tools. Fasteners are freebies.
It got my brain juices flowing.
She tagged us last weekend and we thought we'd give a whirl. Given the pick of 3 tools and 3 resources the challenge is to create a project. Check out her post for details. I first thought I needed to actually build this project, and was happy It was just make believe. This week I have designed a hoop coop to house laying hens. It is light enough to to be moved by hand to get fresh forage to the birds.
(source)
My Resource picks
4 - 2x6x10' boards
3 - 5'x16' cattle panels
4 - five gallon buckets
Tools picks
saw
tin snips
drill
Project Hoop Coop
Step 1
Cut two 2x6 down to 8'
Step 2
Cut each of the four 2' off cuts to 45 degrees at each end (these will be used as corner braces).
Step 3
Screws the 8' and 10' boards together to create a 10'2"x8'2"square (I'm working with rough cut full 2" boards here). Check for square and install the four corner braces.
Step 4
Bend a section of cattle panel so that it sits on the inside of the frame and creates a dome. Screw it in with washers to hold it in place. Repeat for second section.
Step 5
Use the tin snips to cut the third panel in half lengthwise so that you end up with two 5'x8' sections. Fasten each section to the bottom of the frame and attach it to the hoop. Now you'll be looking at a pretty little enclosure.
Step 6
Now is the time cut the nesting boxes. Use the tin snips to cut a 1/3 of the sides from two of buckets. Lay them on their sides and throw some bedding in there for the ladies.
(source)
Step 7
The last two buckets will be fashioned into a waterer and a feeder. With one bucket drill four 2" holes around the sides near the bottom of a bucket. This is where the birds will access their food. Assuming you have some bailer twine in your pocket (c'mon you know you do), tie the feeder to the middle of the hoop.
Step 8
Drill two 1/2 holes in the side near the bottom of last bucket. Screw in two watering nipples (I know it's not in the resources list, but you probably have extras anyway). Fill with water and hang like a feeder.
(source)
Step
Do a dance for completing a hoop coop and find some birds to move in!