HOW TO MAKE STRAP GROUNDING IN KOIL

Hallo steemian.

In this post I will proceed from my post yesterday that is how to make a strap on the ignition motor (Coil ignition).

Tools and materials:

• Ignition coil.
  

• Scissors, Cutter, etc.
  

• Tool pliers
  

• burning insulation / insulation tape.
  

• Cables between 0.75mm to 1mm / long copper wire to taste.
  

-connector (optional).

Stages make it:

1. itemBundle of copper wire to the ignition coil parts firmly and tightly.
   

2. Rolls are not necessary along the coil ignition cable but only about 70 to 80 percent.
   

3. At the end of the coil (cable) is given skun konektor and the end of the cable that leads to spark plug ignore it between 2 - 3 cm from the end of the coil cable.
   

4. The next step is to wrap the coil with insulation insulation / ribbon insulation.
   ![image]
   ()
   

Finally put the coil back in place, and try the starter, usually the effect will be marked with lighter engine langsam and gas response more fierce.

Hopefully this information can be useful.

Thanks.