In this video, I make a knife grinding jig!
its a really solid, and inexpensive jig you can make for under 30 bucks!
hope you like the build and dont forget to leave a comment down below!
If you like these videos, support me over on my Patreon page!
https://www.patreon.com/grazmakes
here is the links to all the stuff I used in this build!
The Graz-Grinder 5000 blueprints! (they are actually black and white):
https://nofile.io/f/PKE61CG48UY/graz+grinder+blueprints%21.pdf
3/8 Inch Aluminum Plate:
https://amzn.to/2HCO6WD
Heim Joint:
https://amzn.to/2sV1Si0
Machine screws:
https://amzn.to/2HFMpHU
1/4 inch Wingnut:
https://amzn.to/2LFaiSn
Threaded Rod:
https://amzn.to/2kZyNhP
Corner Braces:
https://amzn.to/2JJu2a9
Utility Hinges:
https://amzn.to/2JtMLr2
aluminum flat bar:
https://low.es/2JyFiTt
My sweet and inexpensive bluetooth headphones:
http://amzn.to/2oDesRS
Please Like and Subscribe for future videos!
Don't forget to press the little bell notification so you'll know when new videos are released!
Twitter: https://twitter.com/GrazMakes
Instagram: https://www.instagram.com/grazmakes/
Thanks to Charlie Fogel of Plop Culture Prints for the fantastic logo.
https://www.facebook.com/PlopCultureP...
https://www.instagram.com/charliefogel/
Music:
"Full Tilt Slam"
Chapman Brothers Garage
from the album "Third Gear"
Check them out on itunes here:
http://apple.co/2jnHjnZ
If you're digging these videos, please feel free to share them with friends AND enemies!
▶️ DTube
▶️ IPFS