While I was showing components of the Jetbot, I was asked whether I would put them together, the answer was "YES". So now I am going to show the steps of assembling this little so called "Robot". I think it is more like a car than a robot.
在過去的一段時間中, 當我仍是每天的在展示這車的部件時, 有位大哥大問我會否把車組裝起來. 這個當然是會啦. 現在就開始示範如何組裝這車.
Since Jetbot supposed to be moving all the time, in order to get a stable network connection, instead of using USB Wifi dongle, Jetbot use a slot-in Wifi module with external antenna to enhance signal strength. This is the wifi module to be used.
Jetbot選擇了使用這種插入式的Wifi模組,因為考慮到要有外置天線以加強信號收發,以達致四處移動的實際使用情況。
This is the external antenna connector:
這是接駁天線的接頭:
To faciliate installation of the Wifi module later, the 2 connectors were installed as shown at this step.
現在先把兩個兩個天線接頭安裝好, 以方便日後安裝那Wifi模組.