

Hello friends of Hive and DIYhub! I wish you all a Merry Christmas. I have made some beautiful foami flowers, very easy to make and very fast to make.
Here I show you the step by step:
MATERIALS
- Blue, red and yellow frosted foami
- Silicone gun
- Scissors
PROCEDURE
๐ฎ Step 1

On the foami you are going to draw 2.5 inch X 10 inch lines to form ribbons.
๐ฎ Step 2

A single red ribbon is needed to form the flowers.
Then cut the folded foami with the scissors from the middle part that joins the folded ribbon of the foami to both ends of the foami, always at a slant.

๐ฎ Step 3

Afterwards, you will trace on the foami those figures similar to the pistils of the flowers. Then these are cut out.

๐ฎ Step 4

Take the yellow foami pistils and wrap them around the pistil with the red ribbon that has been previously cut.
When doing so, you must have to press and stretch the material at the same time, so that the petals of the flower are open.

This is the only thing you have to do to make the flower, always adjusting the foami with the silicon gun.


Credits
The images are my own and were taken with a ZTE BLADE phone.
Translator utilization: Deepl
The editing of the photos was done using the Polish Photo Editor application and separators were edited in canva.

Hola amigos de Hive y DIYhub! Les deseo una Feliz navidad a para todos. He realizado unas hermosas flores de foami, muy faciles de hacer y muy rapidas fe hacer.

Aqui les muestro el paso a paso:
MATERIALES
- Foami azul, rojo y amarillo escarchados
- Pistola de silicรณn
- Tijera
PROCEDIMIENTO
๐ฎ Paso 1

Sobre el foami se va a trazar lineas de 2,5 pulgadas X 10 pulgadas para formar cintas.
๐ฎ Paso 2

Se necesita una unica cinta roja para formar las flores.
Posteriromente se va a cortar con la tijera el foami doblado desde la parte media que une la cinta doblada del foami hasta ambos extremos del foami, siempre de forma inclinada.

๐ฎ Paso 3

Posteriormente se va a trazar sobre el foami esas figuras parecidas al pistilo de las flores. Luego estos se recortan.

๐ฎ Paso 4

Se toman los pistilos de foami amarillo y con la cinta roja que se ha cortado anteriormente se procede a enrollar alrededor del pisitilo.
Al hacerlo se debe tener hacer presion y estirar a la vez el material, de lat forma que los petalos de la flor esten abiertas.

Esto es lo unico que hay que hacer para hacer la flor, siempre ajustando el foami con la pistola de silicon.


Creditos:
Las imagenes son de mi autoria y fueron Tomadas a traves de un Telefono ZTE BLADE.
Traductor utilizado: Deepl
La edicion de las fotos la realicรฉ mediante la aplicaciones Editor de Fotos Polish y los separadores se editaron en canva.
