ESPAÑOL
Hola amigos de Hive. espero esten bien. Si aun no tiene la estrella del arbol lista, aqui les traigo el paso a paso para realizar una estrella de navidad.

MATERIALES

- Foami escarchado dorado.
- Pistola de Silicón.
PASO A PASO:
1

Lo primero que se hace es trazar sobre el foami lineas muy finas de 0,50 cm aproximadamente.
2

Se cortan las lineas y se van a formar dos caras para crear la estrella. La primera cara que se va a formar se hace con seis tiras de foami de 0,50 cm de ancho y 10 cm de largo.
3

Luego se toma una de las tiras y se va a formar ese lazo que se muestra en la imagen. uno arriba de otro y se crea esa curva.

Esta se pega con el silicon caliente.
4


Es asi que vamos a crear la misma forma de un lazo con las otras tiras. Seis lazo en total para poder formar una cara de la estrella.
5

Luego se van a ir pegando las caras de los lazos como se muestra en la imagen.


Asi sucesivamente se van a ir pegando las caras de los lazos.

Luego se pega la ultima cara de los lazos de foami.
6

Y finalmente se unen ambos extremos de lazos de foami como se muestra.
7

Despues se deben pegar las puntas de cada lazo.

Se debe realizar la union de las puntas de foami con todas las puntas.

Asi deberia de quedar.

Luego se deben pegar don tiras de cintas sobre la estrella y esconderla por la parte de atras de la estrella.
8

Este es el resultado de una de las caras que van a formar la estrella.

Se hace la otra cara de la estrella siguinedo los pasos anteriores.

Luego se forma la otra cara de la estrella y se pegan ambas caras con el silicon Caliente.

gracias a todos!
Creditos:
Las fotos fueron tomadas por un tlf ZTE Blade.
Las fotos son de mi autoria
Traductor: https://www.deepl.com/es/translator
ENGLISH
Hello friends of Hive, I hope you are well. If you still don't have the star of the tree ready, here I bring you the step by step to make a Christmas star.

MATERIALS

- Gold frosted Foami.
- Silicone gun.
STEP BY STEP:
1

The first thing to do is to draw on the foami very thin lines of 0.50 cm approximately.
2

Cut the lines and form two faces to create the star. The first face to be formed is made with six strips of foami 0.50 cm wide and 10 cm long.
3

Then you take one of the strips and form the loop shown in the image, one on top of the other and create that curve.

This is glued with the hot silicon.
4


So we are going to create the same shape of a loop with the other strips. Six loops in total to form one side of the star.
5

Then we are going to glue the faces of the loops as shown in the image.


Then glue the faces of the loops together as shown in the image.

Then glue the last side of the foami loops.
6

And finally join both ends of the foami loops as shown.
7

Then glue the ends of each loop together.

Join the foami ends together with all the ends of the loops.

This is how it should look like.

Then glue two strips of ribbon over the star and hide it on the back of the star.
8

This is the result of one of the faces that will form the star.

The other face of the star is made following the previous steps.

Then form the other side of the star and glue both sides with the Hot Silicone.

thank you all!
Credits:
The pictures were taken by a ZTE Blade tlf.
The photos are of my authorship
Translator: https://www.deepl.com/es/translator