Hi steemians..
Today I want to try to explain about Opacity and Dust Monitor Systems
The cement plant needs a dust monitor systems, because the dust from coal material very dangerous for the environment, it will go out through the stack and damaging the environment around the plant, let say eating too much dust is bad for your health
Innovation
Many country make a new innovation to measure the dust from the stack, I don't want to put the name of the product here, let's call it X200. Opacity and dust monitoring systems provide precision monitoring of particulate concentrations in cement industry for environmental regulation and compliance for opacity or dust measurement
X200 systems have simple menu operation of all features, it can remotely via a main control unit or in the control room via a standard Modbus interface
Total calibration procedures take less than three minutes, a simple push button procedure that requires no special tools or equipment. The Calibration does at Workshop before install at site and working good.
Versatility
One major benefit of the X200 series systems is versatility
The ability of the system to be easily, and cost effectively, interfaced into existing applications in the even of breakdowns with old equipment no longer viable for service
System I/O and control features are fully interchangeable with all known competitor systems, and a wide range of accessory products ensure easy installation on any application
X200 must be audit test every 6 month, and the audit test results showed each test not exceeds. because the operator in cement plant will use this product to monitoring opacity and dust, if the opacity exceeds the range then combustion is reduced to maintain the environment
--Thank you for your time--