Bike Trunk Rack (Bike Carrier) YAKIMA Fullback 3 Used
First, it's a picture of a bicycle. (3 units can be mounted, only two units are equipped)
Actually, after stopping in the middle of the requirement and rearranging it, it is a picture.
I was rushing to get out of there.
The shape of the yaw. (The license plate looks good, it should be right to run like this ??? ..)
I bought the product returned from Ammon Mi-zon because it was a little cheap and I sent a patch to the box to see if the box was torn. But when I opened it, it was completely new. 걍 There was no sign of use in the product so I would have sold it as a pre-sold box. Even sealed (in fact, this could be sealed later, but there was no sign of using it at all).
For reference, approximate size with 500cc water for comparison.
The bike rack itself weighs approximately 10 kg.
After installation
(I'd like to change a little old emblem)
Hitting
(I do not remember how nice it was to get past the army,
Contact with glass
One of the reasons we chose the Yakima products is the contact area. Though I liked Thule's Raceway product, the reason why I did not choose Tully was that the high price, the availability of two, and the small contact area. (Because there is no reason why the pressure will be low if the contact area is too high)
And the arm is extended for bicycle mounting
It's a picture taken from the right side.
It is a picture taken at about 45 degrees in the rear (?).
Once again a side view picture
Picture taken from the rear door side indoors. Rear vision must be given up. The anchor you see is the additional anchor you see on the picture. This product basically hooks up and down four hooks on the trunk and gives tension to fix the bike rack to the trunk. However, in some cases, a vehicle that does not catch a hook is fixed by using an anchor mode, which is inserted into the gap between the trunk and the vehicle body. Or anchors (photo opening) that can slightly reduce the damage of the vehicle are sold separately.
Describing the anchor mode of the manual
And the rubber moldings of the loop part where the anchor on the roof side came into contact after disassembling after turning one round is the state.
left side
And right
(Oh it's so messy)
Last one son and one bicycle before departing the bicycle
Thank you for your look ~~~