A switch I made today with some 3d printed parts and 2 micro switches. I plan to use this on my light controller which is connected to my smartthings hub and is setup with the mlx90393 encoder I am using

3d printed bearing. Trying to get it worn in and running smooth. It runs ok under load but not without load. I think I need to reduce the diameter of the inner race a bit. ▶️ DTube ▶️ IPFS

A project I've been working on for my 4 year old son. I have not seen anything like this, please comment if you are aware of something simular. ▶️ DTube ▶️ IPFS

Rotary encoding with diametric magnet and no physical contact. ▶️ DTube ▶️ IPFS

Using 2 opto interrupters this video demonstrates how to mount them on a board and test that they can emit quadrature encoder signals. My previous video describes how to get the STM32 to read the opto

Hello Steemit, and DTube! I've just started producing content for DTube and Steemit and I was wondering if folks could chime in on this post to comment on the following. For video tutorials do you: Want

Testing the STM32 internal pulldown resistor and an opto interruptor to reduce the total components needed for my encoder project ▶️ DTube ▶️ IPFS

3d printed encoder with opto interrupors for quadrature encoding rotary motion. ▶️ DTube ▶️ IPFS

Drinking in the middle of the day is great.

DIY 3d printed rotary encoder demo with STM32 and WS2812b neopixels. ▶️ DTube ▶️ IPFS

Fun with my image editor and a photo I took from Kerry Park in Seattle Thanks for checking my photo out!

Lovely view from the starter shed of The Preserve If you want to see more please share your comments