https://www.orak11.com/wp-content/uploads/2018/10/Orthodontic-Treatment-Stages.jpg

Orthodontic treatment, it is important for oral health needed to be in order. Therefore, treatment should be administered without delay. Consists of 5 different phases of orthodontic treatment. Stages of the treatment process describes how this is progressing.

Orthodontic treatment consists of a process that is long and requires patience. This treatment process consists of 5 different stages. These examination phase, preparation phase, planning and diagnosis, orthodontic treatment and other treatment stage consists of 5 different phases.

Examination Stage

People crowding in the teeth, curvature, separation, congestion or problems such as jaw disorders should refer to specialists if they would notice. Specialist orthodontics for inspection by contacting the persons should be examined. A specialist in orthodontics, will give information about whether the person must be treated. In the examination, the doctor controls the inside of the patient's mouth in detail. Later, the issue of the treatment that the patient should be made fully according to which the information is given.

Any question is not in the patient's mind, because treatment is required and treatment should be informed in detail about the phases. In this way, the person learning about the stages of treatment, the treatment process learns how to live. During treatment, the patient to be conscious and knowledgeable to help you take care of the patients. Patients are always conscious, in cooperation with the doctor. In this way the treatment process is quite short and is successful.

The Preparation Phase

Examination of orthodontic treatment, after treatment preparations for starting. In the preparation stage are necessary conditions. First, these conditions must be met. Existing within the patient's mouth with the treatment of these problems begins. Orthodontics for dental hygiene is essential. Therefore, the first oral care and hygiene should be performed.First it is checked whether is rotten in the mouth. If there is rotten then it should be treated.All cavities should be taken under control. The Preparation Phase

Dental hygiene is important. Therefore, plaque, tartar and tooth discoloration should be cleaned in consideration of conditions such as. There are problems of the gums in some patients. If you have problems with gums that a person must have a solution. You need to the health of your gums. After reaching the solution of oral problems, the treatment should be recorded. Planning the necessary measurements and analysis should be performed. The Preparation Phase

It is necessary to complete the treatment. Therefore, in order to assist in planning panoramic and cephalometric X-rays X-rays are taken. X-rays are attracting goal inside the mouth, the mouth, teeth, or jaw problems able to see exactly. At the same time, problems such as cysts and tumors that are invisible to the eye whether they are used for control purposes. Mouth, teeth and facial need to be taken their picture. This treatment is used as a guide before and after treatment. Finally, the models of the upper jaw and the lower jaw is taken by. The Preparation Phase

Diagnosis and planning phase

Measurements and analyses after the diagnosis and planning phase begins. At this stage, the patient the diagnosis and the necessary treatment options are offered. From patient to patient and treatment-existing disorders due to varies. Therefore, the orthodontic treatment is given the patient the appropriate and necessary by the specialist. In this case of course the patient's preference are taken into account. During the planning phase, it is important the patient's mouth, teeth and jaw structure. Therefore, by the doctor the patient's mouth, teeth and jaw to determine the appropriate treatment is given according to the structure. Diagnosis and planning phase

After the decision phase it is decided whether the teeth in the patient's mouth to be pulled.According to this situation, tooth extraction is done. Tooth extraction is implemented for each patient. Some people mouth or jaw structures is narrow, because the tooth extraction is needed. The place and location in the mouth helps in the acquisition of the required extraction. At the same time it does not interfere with the movement of the teeth and unwanted tooth movement made for the purpose of termination. After treatment, there is no space between the teeth.Come teeth to the required position. Diagnosis and planning phase

Disorders of the jaw in some patients in the forefront. This situation is further regarded as an orthodontic disorder. Orthodontic advanced orthodontic treatment with the disorder only did not resolve. Therefore, in order to be precise utilities and orthognathic treatment a solution is applied. Orthognathic treatment is the treatment of jaw disorder. Enables surgical procedures to be corrected with jaw disorders. In the absence of sufficient braces jaw disorder, patients surgical intervention is performed. This is not implemented for each patient.If there is consideration at the planning stage in orthodontic disorders in patients with advanced has been recorded. Diagnosis and planning phase

Orthodontic Treatment Phase

The method of orthodontic treatment with a specialist in orthodontics after you have decided on the patient, the treatment process begins. In this process, the phase of the fitting of braces begins. Due to braces oral hygiene during the stage the team becomes dry. Ekartor mouth is attached. This will allow you to work better and the doctor keep the patient's mouth open. Braces are installed using two different methods. These conventional indirect bonding method. Orthodontic Treatment Phase

The traditional method is adhered with the first adhesive brackets on the teeth. The wires arc then passed between the brackets and the tires are fitted. The method is a method of indirect bonding of the new technology. Previously prepared molds and measurements are taken of the patient's mouth. Prepared on the model are placed in brackets. Then, the mold is placed on the teeth and removed. The brackets in this manner is transferred onto the teeth. Finally, the wires are inserted.

Other Treatment Stage

After the end of treatment other orthodontic treatment begins. After the removal of brackets and wires made a transition to consolidation therapy. The reason for this is to prevent the teeth back their old and new position back to retain their positions. Two different methods are applied in the treatment of fixed and movable reinforcement. Other Treatment Stage

Reinforcement therapy for each patient is required because the teeth will try to be back in their original locations. Therefore the treatment should be kept under control by taking precautions. If it is not used if the teeth takes the old form and the treatment will fail.Therefore, the importance and attention to their patients for orthodontic treatment, the treatment should provide reinforcement. WARNING ! Located in our news, written and compiled from different sources of visual content were created to be, is a letter of suggestions and information. Constitutes the definitive diagnosis and treatment. In the face of any health problem contact your doctor.

Posted from my blog with SteemPress : https://www.orak11.com/index.php/orthodontic-treatment-stages/

Topics